Arduino and Raspberry Pi compatible wireless 2.4GHz transceiver
Includes 2.4GHz 2.2dBi duck antenna
Signal PA (Power Amplifier) and LNA (Low-Noise Amplifier) extends the range of this module considerably Applications: wireless peripherals, remote control systems such as RC vehicles and consumer remote electronics, wireless voice transmission such as VoIP, wireless sensor networks, wireless networks, home and commercial automation To maximize the transmission/reception distance (range) we recommend the following:
using a slower data rate, preferrably 250kbps
in addition to the GND header pin we recommend also connecting your source ground to the ground through-holes or castellations near the brass antenna connector
adding a 10uF capacitor across GND and V+ to assist with power demands during transmitting and receiving
using a dedicated 3.3V power source instead of an Arduino's 3.3V supply, a good 3.3V regulator such as the LD33V works well
The module will work without the above recommendations but following the above recommendations will increase the module's total range