DC-DC Step Down Buck Converter Module High Voltage 22V-290V Drop 3.6V-15V Adjustable DC Isolation Switching Power Supply Board
search
  • DC-DC Step Down Buck Converter Module High Voltage 22V-290V Drop 3.6V-15V Adjustable DC Isolation Switching Power Supply Board
  • DC-DC Step Down Buck Converter Module High Voltage 22V-290V Drop 3.6V-15V Adjustable DC Isolation Switching Power Supply Board
  • DC-DC Step Down Buck Converter Module High Voltage 22V-290V Drop 3.6V-15V Adjustable DC Isolation Switching Power Supply Board
  • DC-DC Step Down Buck Converter Module High Voltage 22V-290V Drop 3.6V-15V Adjustable DC Isolation Switching Power Supply Board

DC-DC Step Down Buck Converter Module High Voltage 22V-290V Drop 3.6V-15V Adjustable DC Isolation Switching Power Supply Board

€19.00
Quantity

Wide input voltage: DC 22V-290V
The minimum voltage difference between input voltage and output voltage is 15V
Output voltage: DC3.6V to 15V adjustable
Output: current 600ma (Max) or power 6W (Max); when 22V drops to 5V, the output current is about 200ma, 48V
Reduce 5V, the output current is about 500ma; the higher the input voltage, the stronger the load capacity.
Quiescent current: 0.5Ma (90V down to 5V typical value).
High efficiency: up to 96%
Low standby current;
Built-in over temperature, over current, output short circuit protection
Built-in soft start
Working temperature: industrial grade (-40°C to +85"C)
Module volume: 43*21*17mm

Instructions:
1. First connect the connection line between the module and the power supply before powering on. (If the input terminal is connected with power, it is easy to sparkle
Like, especially when the input power supply voltage is high, the pads of the module may even be burnt).
2. After selecting a suitable power supply, use a multimeter or voltmeter to measure whether the output voltage of the module is the same as the voltage required by the device
Consistent, you can adjust the output voltage (between 3.6V and 15V) by turning the blue adjustable resistor on the board.
3. The electrical equipment (load) is connected to the output terminal of the module.
4. Adjusting the value of the adjustable potentiometer to too large or too small will cause the LED indicator on the board to not light up. At this time, you only need to
The value of the potentiometer can be adjusted back to the appropriate position.
5. When the difference between input voltage and output voltage is less than 15V, the led indicator will not light up.

R3325
3 Items