Flyback Driver Board Zero Voltage Switching F/ FBT Inductive Heater

Features:

1. size: 74 mm * 77 mm
2. input voltage: 12V-30V recommended 24V
3. Power supply requirements: less than 15V≧ 5A; 15V or more≧15A
4. Operating frequency: 30KHZ - 60KHZ
5. Secondary parameters: 5T+ 5T
6. Use military 1.6mm double board, four fixed 3 mm hole.
7. Mixer tube to add new field with a 30mm large heat sink, greatly improve the stability and life!
8. Low density component placement, better heat dissipation, Especially the capacitance, the majority of ZVS plate will be 2 capacitance placed side by side!
9. Extra power line tin, current-carrying capacity more strong!
10. Metal film resistor power, high precision, small Temperature drift!

Input voltage:12V   
Output voltage:About 1000V   
Average power:50W   
Maximum power:100W   
Arc length:2-4CM   
 
Input voltage:24V   
Output voltage:About 2000V   
Average power:100W   
Maximum power:200W   
Arc length:5-8CM   

• 12-30VDC input (recommend 24V), output high voltage direct current, voltage of the input  voltage of about 1000 times. The 12V input can reach 50-100W power, 24V input max can reach more than 200W, so request power supply current best in more than 10A.   
  
   
• A flyback drive circuit, which is used to drive the ignition coil, as did the Zero Voltage Switching,masses of fans called them "ZVS circuit". Because of its big power, low heat, simple and reliable by fans are widely used in the drive spark gap tesla coil (SGTC) and Jacob, ladders, Marx generator, etc.